Essential 3D Printing Tips For Beginners

Essential 3D Printing Tips For Beginners

This essential guide to 3D printing teaches you the fundamental concepts of this technology and provides resources to help you get started. It also includes articles on Leveling your 3D printer bed, increasing the wall or shell thickness, using supports, and avoiding warping. It is a great place to start for beginners, and it is updated on a regular basis. Moreover, the articles are easy to understand and follow.

Leveling the bed of a 3D printer

Leveling the bed of a 3D printer

One of the most important things for a 3D printer is a level print bed. A level bed ensures that the filament will stick to it and provides a secure base for your print job. There are several methods to level the build bed. Mechanical leveling is the easiest, and you can also use rafts or shims to raise or lower it as needed. The next step is to test the print bed by moving the nozzle over the screws to see if there are any shifts.

Increasing wall or shell thickness

When it comes to 3D printing for beginners, increasing wall or shell thickness is an essential part of the print process. Too thin of a wall can cause the print to crack or otherwise fail to look as intended. This will require adjusting the design, or changing the print process to achieve the desired thickness. The wall thickness you choose will also depend on the structure of the 3D model you’re printing. For example, if the print requires a 5mm-thick vertical wall, you’ll need a 0.3-mm wall thickness, while for a one-inch-thick vertical wall with a 100-mm-wide surface, you’ll need to increase the wall thickness to a 1mm-thick wall.

Using supports

The first step in using supports is to make sure that they are in the correct position. There are several ways to make sure that they are in the correct place. You can choose to have your supports enforced anywhere on your model, or you can make sure that they only apply to specific areas. To make sure that the supports are placed in the correct place, you need to make sure that you are using a support that is set to the appropriate density, Check out the post right here.

Avoiding Warping

Avoiding Warping

Warping is common during the 3D printing process, and the best way to avoid it is to keep the infill level low. While higher infill levels can increase the thickness of the printed object, they decrease the durability of the print. A good rule of thumb is 20 to 25 percent. In addition to infill level, there are other things you should consider to avoid warping. 

Calibration of Your 3D Printer

Before you start printing, you should perform the calibration process of your 3D printer. There are many components that your 3D printer contains, from the filament to the print bed. Calibration of your 3D printer will help you avoid these scenarios and ensure that each print is exactly the same. By following some basic calibration procedures, you can achieve the highest quality prints from your printer. But how do you perform this procedure?